Bad extrusion at high speeds

Подписаться на 3Dtoday
Mark
Идет загрузка
Loading
25.10.18
64
1
prints with Anet A6
Questions and answers
Everything works fine at low speeds, but once I rev it up, plastic barely gets squeezed out. What does it mean? Is the nozzle getting clogged?
Responses

Replies

25.10.18 в 13:04
prints with Ultimaker 2
0
If there is nothing wrong with extrusion at low speeds, then nozzle has nothing to do with it. Either the plastic isn’t being heated fast enough, or it’s not sufficiently fluid. For starters try raising temperature by 7-10 degrees.

Please log in to leave a comment.